Simrad Rf300 Installation Manual May 2026

While it is a two-wire system, always follow the specific wiring diagram in your autopilot computer manual to ensure the frequency signal is correctly interpreted.

Before securing the unit, rotate the transmitter lever until the alignment marks are perfectly centered. These marks should be opposite the cable entry point of the feedback unit. Tiller Arm Connection: simrad rf300 installation manual

Install the RF300 on a stable platform near the rudder post. The center of the RF300 should ideally be in line with the center of the rudder post to ensure geometric accuracy. While it is a two-wire system, always follow

Ads
`);doc.close();}