The EGS002 is a digital, fully functional pure sine wave inverter driver board with dead-band control. It uses the as the main control chip, which handles: Voltage, current, and temperature protection. LED alarm functions. Fan control. SPWM generation (50Hz or 60Hz).
Run the simulation. You should see a high-frequency PWM signal before the filter and a smooth 50/60Hz sine wave after it. Common Troubleshooting Tips egs002 proteus library
Since Proteus doesn't come with this component, you must add the library files manually. The EGS002 is a digital, fully functional pure
In a real-world circuit, the EGS002 connects to a power H-bridge to convert DC into AC. Simulating this before soldering prevents costly "magic smoke" moments. How to Install the EGS002 Proteus Library Fan control
Once installed, you can find the device by pressing in the schematic capture window and typing "EGS002." 1. Basic Circuit Setup
Connect Channel A to one side of your LC filter and Channel B to the other. Set the oscilloscope to "AC" mode.
This is crucial. Use an inductor (approx. 2.2mH) and a capacitor (approx. 2.2uF) to "smooth" the SPWM pulses into a clean sine wave.