: Standard CDM9 supports doors up to 400 kg; the HD version handles up to 800 kg. Supply Voltage : 230V AC, single phase, 50/60Hz. Operating Temperature : -20°C to +55°C. Mechanical Installation Steps
: The operator should be installed at least 2.5 meters above the floor for safety. Electronic Setup and Commissioning (ECS 950)
The ECS 950 control unit uses several internal cards, including the (standard functions) and the manoeuvring card , which features status LEDs for the stop circuit and limit switches. crawford cdm9 950 installation manual
Use the "Hold-to-run" command (pressing the Up/Down buttons) to bring the rubber sealing edge to the 1m mark.
The ECS 950 Service Tool Manual identifies key issues through a service lamp and error codes. : Standard CDM9 supports doors up to 400
The Crawford CDM9 complete set typically includes a 0.37 kW motor, approximately 60 Nm of torque, and a 10-meter cable for connection between the motor and the control box. : 340 x 230 x 140 mm.
: Any fault in the safety edge will force the door into "Hold-to-run" mode for closing as a safety precaution. Mechanical Installation Steps : The operator should be
: Check if the operator is accidentally disengaged or if the contacts (X4/X5) in the control box lid are loose.