Before installation, ensure your hardware meets these specifications to prevent software lag or connection drops:
Run the installer provided via the Carrier software portal or USB drive. Follow the prompts to install the CCN drivers.
If the COM port does not appear, reinstall the USB-485 drivers via the Device Manager. Carrier Network Service Tool V Manual
Ensure the network is properly terminated with a 100-ohm resistor if you are at the end of a long wire run. Best Practices for Field Technicians
Do you need help (e.g., lead/lag settings)? Ensure the network is properly terminated with a
Upon first launch, you will be prompted for a license key. This is typically provided by your local Carrier distributor. Interface Configuration: Open the "Communications" menu.
Permanent settings such as setpoint limits, delay timers, and equipment stages. Alarm Management This is typically provided by your local Carrier distributor
Real-time sensor readings (temperatures, pressures, setpoints).